BZ-7223

1/3- and 1/1-octave frequency analysis application for Types 2250 and 2270

Enable real-time analysis of 1/1- and 1/3-filter bands over a wide frequency range

Request a quote

The application measures a dynamic range from the noise floor in each individual band to a maximum level of 140 dB.

Spectral data can be measured for five different parameters: Leq, LFmax, LFmin, LSmax and LSmin. You can select which frequency weighting (A, C or Z) during the measurement setup. In addition, instantaneous values are available for display.

USE SCENARIO

  • Environmental noise assessment
  • Occupational health assessment

With a single, wide dynamic range, combined with simultaneous measurement of RMS and peak levels with different frequency and time weightings, you can gather all information in one go.

The colour display provides spectral data graphically, clearly providing a wealth of data and measurement quality information in an easy-to-navigate way. Two spectra can be superimposed on the display.

Results from data analysis can be used in a variety of ways, including selection of hearing protection and product quality control.

CAPABILITIES

  • 1/1-octave spectra (centre frequencies 8 Hz to 16 kHz) and down to 1 Hz with very low frequency option
  • 1/3-octave spectra (centre frequencies 6.3 Hz to 20 kHz) and down to 0.8 Hz with very low frequency option
  • Spectral statistics based on LAeq, LAF or LAS
  • Loudness and noise rating (NR) curves supported
  • Programmable generator available for measurements requiring a sound source

Upcoming courses and webinars

3일 소음진동분석실무 분당 08 May 2019 33만원(MS), 99만원(일반) Read more
2 Tage S3 "Bestimmung der Schallleistung von Maschinen und Anlagen nach der Druck- und Intensitätsmethode" Köln 08 May 2019 EUR 828,- zzgl. MwSt. Read more
1 hour BK Connect™ Английский 08 May 2019 Free Read more