TYPE 2670-WB-1419

¼-inch microphone preamplifier, integral 2m cable with 7-pin LEMO plug

Designed to operate over a wide range of temperature, humidity and other environmental conditions. Optimised for airbag measurements.

견적 요청하기

USE SCENARIOS

  • For airbag measurements

FEATURES

  • The preamplifier, cable and its connectors all fulfil electromagnetic compatibility (EMC) requirements
  • LEMO connector for instrument input socket
  • Patented charge injection calibration (CIC) technique for on-site calibration of the whole measuring channel including the microphone
  • Wide dynamic range
  • Very low inherent noise, high input impedance
  • Low output impedance and high output current allow use with long extension cables
  • Wide working temperature range
  • Excellent phase linearity

The low output impedance and high output current capability mean that you can use long cables between the preamplifier and your measuring instrument without loss of signal quality. 

The high distortion limit together with an extremely low inherent noise level gives a wide dynamic range. You can connect ¼" microphones directly and 1/8''-types using an adaptor. 

Diameter
1/4
Optimised for
Airbag
Connector at preamplifier
Fixed (2 m)
Connector at instrument/cable
LEMO 1B, 7-pin
Polarization voltage support
Yes
Supply voltage
± 14 to ± 60
Max output voltage (peak)
55
Max output current (peak)
20
Frequency range
1 to 100000
Attenuation
11
Noise A-weighted, typical
4
Noise 22,4 Hz to 300 kHz, typical
14
Input impedance
15||15
TEDS UTID
1025 from serial number 2264319